OUR REMORA STRAP MADE IN HIGH QUALITY RUBBER REM22 IS DESIGNED TO BE SIZED
This quick guide will teach you how to go about it in the most suitable way.
How do you know if your watch strap can be sized? A rubber (or silicone) watch strap that can be sized will have many holes along the edge of the strap and lines inside the strap. How to size the bracelet?
1. Remove the clasp from the bracelet. For this purpose, we have provided spring bars. For spring bars, you can use a pin or other small tool that goes into the hole enough to press down on the spring bar and slide the bracelet away from the clasp.
2. Carefully use the lines on the inside of the bracelet to cut each section until you get the desired size.
For the best fit, you may need to cut off a section, then put the strap back together, try it on, and repeat if the watch is still too big on your wrist.
Be sure to cut exactly along the line so you don't get too close to the hole, otherwise there may not be enough rubber around the spring bar to create a secure fit with the clasp.
3. Insert the spring bar into the new hole and reattach the bracelet to the clasp. You will need to put one side of the spring bar into a hole in the clasp, and while holding it, use a tool or your fingernail to push the other end of the spring bar enough to slide under the clasp in the opposite hole.
We have planned this operation as simple as possible, but this part can be tricky. N.B.: Do not cut too many sections of the bracelet and do not cut beyond the number of holes on the edge. As long as there are available holes along the edge, you can go smaller, but you can never go bigger!